Are your Leak Detection services available in Fallon?

Yes, Masters Plumbing Service provides round-the-clock Leak Detection services directly in Fallon, NV.

How much does emergency service cost in Fallon?

We offer upfront, transparent pricing with no hidden fees for all service calls in Fallon.

🔍 Non-Invasive Detection Technology

Leak Detection in Fallon, NV — Find It Before You Open a Wall

Name: Masters Plumbing Service
Telephone: +1-855-718-1500
Price range: $$
Rating: 4.9

A water bill that jumped 30% with no change in usage. A ceiling stain that keeps reappearing after patches. A soft spot in the flooring with no visible source. These are signs of a hidden leak that's been running long enough to cause structural damage — and every day it runs is money lost and damage accumulating. Masters Plumbing Service uses acoustic ground microphones, thermal imaging cameras, and precision pressure testing in Fallon, NV to locate leaks without speculative demolition.

📞 Call +1-855-718-1500 — Find Your Leak Today

Acoustic Ground Microphones Thermal Infrared Cameras Pressure Decay Testing Slab & Wall Leak Specialists

Licensed Leak Detection service in Fallon, NV - Masters Plumbing Service

Our Detection Methods

The Tools Behind Accurate Leak Detection in Fallon, NV

A pressure test tells us a leak exists and how much water is escaping. Detection equipment tells us precisely where.

🎙️

Acoustic Ground Microphone

Pressurized supply line leaks create a distinctive low-frequency sound as water escapes the pipe and contacts surrounding soil or structure. Our acoustic listening devices amplify this signal, filtered for background noise, so we can walk a grid pattern and triangulate the loudest point — often to within 6–12 inches of the actual break.

🌡️

Infrared Thermal Camera

Active water leaks — hot or cold — create a temperature differential on the surfaces they contact. An infrared camera shows these differentials as color-coded heat maps, revealing the wet zone inside a wall or under a floor without any cutting. A cold water leak behind drywall appears as a spreading blue-gray cool zone; a hot water leak shows the inverse.

📉

Pressure Decay Testing

Pressure decay testing is the standard by which we confirm a leak is present before committing detection equipment time. It also tells us approximately how significant the leak is — a rapid pressure drop vs. a slow one indicates the size of the escape point.

💨

Tracer Gas Detection

Tracer gas detection is the method of last resort for the most challenging cases — it adds cost and setup time. We use it when acoustic and thermal methods haven't produced a definitive location and the evidence clearly supports an active leak.

What We Locate

Leak Detection for Walls, Slabs, Pools & Irrigation in Fallon

Hidden leaks occur in different locations throughout a property — each requiring a slightly different detection approach. Here's how we handle the most common scenarios in Fallon, NV.

Under Slab

Slab Leak Detection

Supply lines run under or through the concrete slab in most slab-on-grade homes. When these lines fail — from corrosion, shifting, or manufacturing defects — the leak is invisible from the surface but audible to acoustic equipment. We walk the floor on a grid pattern, map the loudest detection points, and triangulate to a specific floor location, typically within a square foot.

In-Wall

In-Wall & Ceiling Leak Detection

We document the thermal anomaly, mark the approximate pipe location, and recommend a minimal access cut rather than a wide wall opening.

Water Main

Underground Supply Line Detection

Supply lines between the meter and the structure run underground and are vulnerable to corrosion, ground movement, and tree root damage. A main supply line leak shows as unusually high meter usage with all interior fixtures off, sometimes with wet ground or sinkholes along the line path. Acoustic detection locates the failure in the buried line precisely enough to minimize excavation footprint.

Pool & Irrigation

Pool Line & Irrigation Leak Detection

Irrigation system leaks in main supply lines and lateral runs are found by isolating zones with the irrigation controller and pressure-testing each zone individually. Zone by zone testing narrows the failure to the smallest possible section.

Commercial

Commercial Property Leak Detection

Multi-story buildings, commercial kitchens, retail spaces, and industrial properties have complex pipe networks where a supply or drain leak can go undetected through multiple floors before surfacing. We approach commercial detection systematically — zone by zone pressure isolation, thermal scan of suspect surfaces, and acoustic confirmation.

Documentation

Leak Detection Report for Insurance

We format detection reports specifically for insurance submission and can provide documentation on our detection equipment and methodology to claims adjusters on request.

📞 Call +1-855-718-1500 — Locate Your Leak

Our Process

From Water Bill Spike to Confirmed Leak Location — 4 Steps

Here's exactly how a Masters Plumbing Service leak detection call plays out.

Initial Water Loss Confirmation

We start at the meter. All fixtures off, we watch the meter for 10 minutes. Movement confirms active water loss from the supply side. We also check for any visible evidence — water stains, soft floors, moisture readings with a moisture meter at suspect wall surfaces.

Zone Isolation & Pressure Decay

Zone isolation is the step that turns "there's a leak somewhere in the house" into "the leak is on the hot side supply, between the water heater and the master bath."

Detection Equipment Deployment

Within the isolated zone, we deploy thermal imaging first — scanning walls, floors, and ceilings for moisture anomalies. Then acoustic equipment confirms the specific pipe location and narrows it to the tightest possible point. Tracer gas is added if acoustic results aren't conclusive.

Written Report & Repair Options

You receive a written detection report including pressure test results, detection method summary, leak location (described relative to fixed reference points), and thermal imagery. If you want us to repair the leak, we quote the repair and execute immediately. If you have your own plumber, the report gives them everything they need.

Customer Reviews

Real Leak Detection Reviews from Fallon

★★★★★

My water bill doubled over three months with no change in usage. Masters Plumbing Service came out, confirmed the meter was moving with everything off, isolated the cold supply to the kitchen as the failing branch, and used the acoustic device on the slab to pinpoint a location 4 feet from the outside wall under the kitchen floor. The repair crew opened a 10-inch circle in the tile, found a pinhole in a copper elbow exactly where detection said it would be. I was skeptical acoustic detection was that precise — it was.

— C. Thornton, Fallon

★★★★★

Our insurance company required professional leak detection documentation before approving the claim. Masters Plumbing Service's written report with pressure test data and thermal imagery was exactly what the adjuster needed. Claim approved. The detection cost was covered as part of the claim.

— B. Osei, Fallon, NV

★★★★★

Pool was losing 2 inches of water per day — more than evaporation could explain. Masters Plumbing Service pressure-tested the plumbing circuit, isolated the issue to the return line, and ran acoustic detection along the line path to find the failure at a union fitting under the decking. Repair required pulling one deck board instead of the exploratory digging another company had proposed. Excellent, focused work.

— T. Anand, Fallon, NV

Trusted Leak Detection service in Fallon, NV - Masters Plumbing Service

Common Questions

Leak Detection Questions from Fallon, NV Property Owners

The most reliable self-check: shut off every fixture and appliance in the house, then watch the water meter for 15 minutes. Any movement — including the small leak indicator dial — means water is escaping the supply side somewhere. If the main meter dial moves with everything off, you have a leak. Call us to locate it.

In most cases, yes — the detection phase is entirely non-invasive. We locate the leak using acoustic, thermal, and pressure methods without any demolition. The detection tells us exactly where to open, which means the access opening is minimal rather than speculative.

For leaks in plastic pipe, low-pressure situations, or high-noise environments, accuracy may be lower and tracer gas becomes the preferred supplemental method.

We can provide supplemental information to claims adjusters on request, including equipment calibration records and a technical description of the detection methodology used.

A standard residential leak detection — confirming water loss, isolating the failing zone, and deploying detection equipment to locate the failure — typically takes 1.5–2.5 hours. More complex scenarios (multi-zone commercial, large properties, very slow leaks requiring tracer gas) can run 3–4 hours.

The repair quote is given before any wall or floor is opened. You know the full cost of detection + repair before anything is cut.

Leak Detection in Fallon, NV — Find It Before You Open a Wall